Eden HA2000 Dokumentacja Pobierz pdf (Strona 37)

Press “#”, HA2000K sounds a long beep

Step 6. Press”

” twice to exit Test mode and

the installation is completed.

z Functions Overview:

z Arm — Anyone of Control Panel user codes

+ “

”

z Part Arm — Anyone of Control Panel user

codes + “

”

PROBLEM? 21

Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to

help you make a perfect installation.

z Disarm — Anyone of Control Panel user

codes + “

”

z Enter Test mode — HA2000K PIN code +

“

”

z Panic Alarm — “1” + “3” simultaneously

z Fire Alarm — “4” + “6” simultaneously

z Medical Alarm — “7” + “9” simultaneously

z Test Mode:

The Test mode enables the following functions:

z Transmit HA2000K learn signal — “

” +

“7”

z Dual-key Panic Alarm Enable —“

” + “2”

z Dual-key Fire Alarm Enable —“

” + “3”

z Dual-key Medical Alarm Enable —“

” +

“4”

z Change the Pin Code –“

” + “6”

z Old Pin Code + “”

z New 4-digit Pin Code + “ # ”

z Dual Key Disable –“

” + “5”

z Quit Test Mode — “

” + “ ”

z Arm/ Home without PIN Code — “

“ +

“8”

z Arm/ Home with PIN Code — “

“ + “9”

z Appendix

If you have forgotten the Pin Code or anything wrong

happened in the HA2000K, you can reset the

HA2000K to factory default and reinitialize it.

Reset to factory default:

Step 1 Remove one of the batteries and release

the tamper

Step 2 Press “3” while inserting the removed

battery back in

Step 3 Continue pressing “3” until 3 short beeps

to indicate successful reset

Step 4 Release “3”



) After reset, PIN code reverts to factory

default values, “0000”. HA2000K will

need a new learn-in process to start

functioning.

z Change of battery

Step 1 Put the Control Panel to programming

menu.

Step 2 Dismount the HA2000K, by first removing

the slide-out sections then the mounting

screws.

Step 3 Open the Keypad by loosening the 2

fixing screw located behind the

HA2000K.

Step 4 Take out the old battery and wait for 5

minutes to replace the new battery in the

battery compartment, with unmarked

(negative) side of battery facing down.

Step 5 Close the case using the rear fixing

screws.

Step 6 Screw back the HA2000K to the surface

with mounting screws, and then re-insert

the slide-outs.

Step 7 Put the Control Panel to exit

Programming Menu.

1 2 ... 32 33 34 35 36 37 38 39 40 41

Komentarze do niniejszej Instrukcji

Brak uwag

Eden HA2000 Dokumentacja Strona 37

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Systemy kontroli dostępu bezpieczeństwa Eden HA2000